To begin the receiver configuration process click on the ‘config’ tab on the left hand side of your screen followed by receivers.

Once on this screen you need to fill out the information required. Begin by entering the names of the space that the receiver is located and then the physical location of the device (eg- café- milk fridge). You then need to select the device type and following your selection a new option will appear allowing you to change the baud rate. It is recommended however that you leave the rate at the pre-set speed of 9600. The final selection requires you to enter the connection type which is referring to the comport number that the device is using. Once you have entered all of this information simply click add receiver.

Your receiver and its corresponding information will then appear at the top of your screen. Here you are also given the option to edit or delete information when required.